Why Does My Bosch Washing Machine Trip the Electrics?
Do not reset the protection repeatedly or use the washer; switch off, unplug if dry and safe, and arrange a qualified Bosch engineer (about 5 minutes).
Fault description
The washer is tripping the electrical protection; Bosch lists possible internal causes including motor, heater, suppressor, shorted wiring or water on an electrical part.
Do not reset the protection repeatedly or use the washer; switch off, unplug if dry and safe, and arrange a qualified Bosch engineer. Record the E-Nr, programme stage and any code without opening the washer.
Causes
- Electrical or heating-related fault — Bosch lists several possible internal causes; the symptom is not a safe user diagnosis.
- Damaged wiring or component — A short circuit, overheating or insulation fault requires qualified measurement.
- Moisture or leakage near electricity — Do not touch the plug or socket if wet; isolate power safely elsewhere.
- Overheating or charred odour — Continued use can worsen damage and must not be tested with another programme.
Step-by-Step Fix
- 1
Stop immediately
Wait for the drum to stop and do not force the door.
- 2
Make power and water safe
Do not reset the protection repeatedly or use the washer; switch off, unplug if dry and safe, and arrange a qualified Bosch engineer.
- 3
Record the evidence
Photograph the display and note the E-Nr, programme stage, noises, odour and whether protection tripped.
- 4
Follow only the exact manual
Perform only external user checks specified for the exact model.
- 5
Do not restart after a safety symptom
For a burning smell or tripped protection, keep the washer disconnected until inspected.
- 6
Arrange Bosch service
Provide the E-Nr and observations. Do not remove panels or test internal components.
When to call a service technician
A burning smell and repeatedly tripped electrical protection require immediate stop-use and Bosch service. A programme that repeatedly fails after the manual's external checks also needs diagnosis.
Do not remove panels or inspect the motor, heater, suppressor, wiring, pump or control board yourself.
Prevention
Follow load, installation and maintenance instructions for the exact E-Nr and keep visible hose connections dry and undamaged.
Internal electrical faults and overheating cannot be safely prevented or diagnosed by user maintenance.
Spare parts and service
Visit our partners for spare parts and service
Spare parts
Book a repair
Frequently Asked Questions
Can I keep using a Bosch washer showing trips the electrics?
Do not reset the protection repeatedly or use the washer; switch off, unplug if dry and safe, and arrange a qualified Bosch engineer. Do not run another cycle until Bosch guidance or service confirms it is safe.
Can I reset trips the electrics by switching the washer off?
Switching off is a safety step, not proof that the fault is repaired. If the code returns or Bosch classifies it as service-only, do not repeatedly reset the washer.
Does trips the electrics identify a part to replace?
No. The code identifies a system or condition, but Bosch service should diagnose the exact cause before any part is ordered.
Why should I provide the E-Nr?
Bosch model families and markets can use different hardware and service procedures. The E-Nr identifies the correct appliance documentation.
May I test the sensor myself?
No. Do not remove panels or measure internal wiring, sensors or electronics. Bosch directs these codes to customer service.