Washing Machine Vibrating Excessively
Check transit bolts on a new installation, level all feet, provide clearance and redistribute the load (about 5–30 minutes).
Fault description
The washer moves or vibrates more than expected.
Check transit bolts on a new installation, level all feet, provide clearance and redistribute the load. Unplug before cleaning or external checks and never open appliance panels.
Causes
- Transit bolts still fitted — Check this only through user-accessible, model-specific steps in the manual.
- Washer not level or floor unstable — Check this only through user-accessible, model-specific steps in the manual.
- Unbalanced or unusual load — Check this only through user-accessible, model-specific steps in the manual.
- Internal suspension or mechanical fault — Check this only through user-accessible, model-specific steps in the manual.
Step-by-Step Fix
- 1
Stop safely
Pause the programme, wait for the drum to stop and do not force the door.
- 2
Check settings and symptoms
Check transit bolts on a new installation, level all feet, provide clearance and redistribute the load.
- 3
Record details
Note the programme stage, any code and the PNC/product number.
- 4
Follow the exact manual
Perform documented user checks only; dismantle nothing and make no electrical measurements.
- 5
Arrange service
Stop if the issue remains or the seal, heater, motor, electronics or internal mechanics are suspected.
When to call a service technician
Arrange authorised service if the problem remains after external checks. Do not use the washer with a damaged seal, leakage or abnormal mechanical movement.
Unplug immediately for water near electricity, burning smell, smoke, abnormal heat, tripped protection, sparks or severe grinding or scraping.
Prevention
Follow load limits, empty pockets, close zips, leave the door ajar after use when safe and clean the seal and accessible areas as the manual specifies.
Keep the washer level and select the correct programme; this does not prevent internal component faults.
Spare parts and service
Visit our partners for spare parts and service
Spare parts
Book a repair
Frequently Asked Questions
Can I keep using a Bosch washer showing —?
Check transit bolts on a new installation, level all feet, provide clearance and redistribute the load. Do not run another cycle until Bosch guidance or service confirms it is safe.
Can I reset — by switching the washer off?
Switching off is a safety step, not proof that the fault is repaired. If the code returns or Bosch classifies it as service-only, do not repeatedly reset the washer.
Does — identify a part to replace?
No. The code identifies a system or condition, but Bosch service should diagnose the exact cause before any part is ordered.
Why should I provide the E-Nr?
Bosch model families and markets can use different hardware and service procedures. The E-Nr identifies the correct appliance documentation.
May I test the sensor myself?
No. Do not remove panels or measure internal wiring, sensors or electronics. Bosch directs these codes to customer service.